faqs.org - Internet FAQ Archives

RFC 4649 - Dynamic Host Configuration Protocol for IPv6 (DHCPv6)


Or Display the document by number




Network Working Group                                            B. Volz
Request for Comments: 4649                           Cisco Systems, Inc.
Category: Standards Track                                    August 2006

         Dynamic Host Configuration Protocol for IPv6 (DHCPv6)
                      Relay Agent Remote-ID Option

Status of This Memo

   This document specifies an Internet standards track protocol for the
   Internet community, and requests discussion and suggestions for
   improvements.  Please refer to the current edition of the "Internet
   Official Protocol Standards" (STD 1) for the standardization state
   and status of this protocol.  Distribution of this memo is unlimited.

Copyright Notice

   Copyright (C) The Internet Society (2006).

Abstract

   This memo defines a new Relay Agent Remote-ID option for the Dynamic
   Host Configuration Protocol for IPv6 (DHCPv6).  This option is the
   DHCPv6 equivalent for the Dynamic Host Configuration Protocol for
   IPv4 (DHCPv4) Relay Agent Option's Remote-ID suboption as specified
   in RFC 3046.

Table of Contents

   1. Introduction ....................................................2
   2. Requirements Terminology ........................................2
   3. The Relay Agent Remote-ID Option ................................2
   4. DHCPv6 Relay Agent Behavior .....................................3
   5. DHCPv6 Server Behavior ..........................................3
   6. Security Considerations .........................................3
   7. IANA Considerations .............................................4
   8. Acknowledgements ................................................4
   9. References ......................................................4
      9.1. Normative References .......................................4
      9.2. Informative References .....................................4

1.  Introduction

   DHCPv6 [1] provides IP addresses and configuration information for
   IPv6 clients.  It includes a relay agent capability, in which
   processes within the network infrastructure receive multicast
   messages from clients and relay them to DHCPv6 servers.  In some
   network environments, it will be useful for the relay agent to add
   information to the DHCPv6 message before relaying it.

   The information that relay agents supply can also be used in the
   server's decision making about the addresses, delegated prefixes [4],
   and configuration parameters that the client is to receive.

   The memo specifies the DHCPv6 equivalent of the DHCPv4 Relay Agent
   option's Remote-ID suboption as specified in [2].  The motivation and
   usage scenarios are provided in [2].

2.  Requirements Terminology

   The key words "MUST", "MUST NOT", "REQUIRED", "SHALL", "SHALL NOT",
   "SHOULD", "SHOULD NOT", "RECOMMENDED", "MAY", and "OPTIONAL" in this
   document are to be interpreted as described in [3].

3.  The Relay Agent Remote-ID Option

   This option may be added by DHCPv6 relay agents that terminate
   switched or permanent circuits and have mechanisms to identify the
   remote host end of the circuit.

   The format of the DHCPv6 Relay Agent Remote-ID option is shown below:

        0                   1                   2                   3
        0 1 2 3 4 5 6 7 8 9 0 1 2 3 4 5 6 7 8 9 0 1 2 3 4 5 6 7 8 9 0 1
       +-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+
       |       OPTION_REMOTE_ID        |         option-len            |
       +-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+
       |                       enterprise-number                       |
       +-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+
       .                                                               .
       .                           remote-id                           .
       .                                                               .
       +-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+

       option-code        OPTION_REMOTE_ID (37)

       option-len         4 + the length, in octets, of the remote-id
                          field.  The minimum option-len is 5 octets.

       enterprise-number  The vendor's registered Enterprise Number as
                          registered with IANA [5].

       remote-id          The opaque value for the remote-id.

   The definition of the remote-id carried in this option is vendor
   specific.  The vendor is indicated in the enterprise-number field.
   The remote-id field may be used to encode, for instance:

   o  a "caller ID" telephone number for dial-up connection
   o  a "user name" prompted for by a Remote Access Server
   o  a remote caller ATM address
   o  a "modem ID" of a cable data modem
   o  the remote IP address of a point-to-point link
   o  a remote X.25 address for X.25 connections
   o  an interface or port identifier

   Each vendor must ensure that the remote-id is unique for its
   enterprise-number, as the octet sequence of enterprise-number
   followed by remote-id must be globally unique.  One way to achieve
   uniqueness might be to include the relay agent's DHCP Unique
   Identifier (DUID) [1] in the remote-id.

4.  DHCPv6 Relay Agent Behavior

   DHCPv6 relay agents may be configured to include a Remote-ID option
   in relayed (RELAY-FORW) DHCPv6 messages.

5.  DHCPv6 Server Behavior

   This option provides additional information to the DHCPv6 server.
   The DHCPv6 server, if it is configured to support this option, may
   use this information to select parameters specific to particular
   users, hosts, or subscriber modems.  The combined enterprise-number
   and remote-id SHOULD be considered an opaque value, with policies
   based on exact string match only; that is, the remote-id field SHOULD
   NOT be internally parsed by the server.

   There is no requirement that a server return this option and its data
   in a RELAY-REPLY message.

6.  Security Considerations

   See [1] section 21.1, on securing DHCPv6 messages sent between
   servers and relay agents, and section 23, on general DHCPv6 security
   considerations.  [2] discusses how this information can be used to
   enhance trust in some environments.

   Note that even if the DHCP server trusts the relay agent not to
   modify information provided in this option, the confidence in that
   information is no higher than the confidence that the relay agent has
   in the information it puts in the option.  For example, in some
   protocols it may be possible for a DHCP client to spoof or otherwise
   choose port identifiers, caller ID information, or other information
   carried in this option.  Sites should consider such possible spoofing
   and how likely it is in their environment when deciding what uses of
   this option are appropriate.

7.  IANA Considerations

   IANA has assigned the DHCPv6 option code 37 for the Relay Agent
   Remote-ID Option.

8.  Acknowledgements

   Thanks to Michael Patrick for [2], from which I've liberally borrowed
   text.

9.  References

9.1.  Normative References

   [1]  Droms, R., Bound, J., Volz, B., Lemon, T., Perkins, C., and M.
        Carney, "Dynamic Host Configuration Protocol for IPv6 (DHCPv6)",
        RFC 3315, July 2003.

   [2]  Patrick, M., "DHCP Relay Agent Information Option", RFC 3046,
        January 2001.

   [3]  Bradner, S., "Key words for use in RFCs to Indicate Requirement
        Levels", BCP 14, RFC 2119, March 1997.

9.2.  Informative References

   [4]  Troan, O. and R. Droms, "IPv6 Prefix Options for Dynamic Host
        Configuration Protocol (DHCP) version 6", RFC 3633, December
        2003.

   [5]  IANA, "Private Enterprise Numbers",
        <http://www.iana.org/assignments/enterprise-numbers>.

Author's Address

   Bernard Volz
   Cisco Systems, Inc.
   1414 Massachusetts Ave.
   Boxborough, MA  01719
   USA

   Phone: +1 978 936 0382
   EMail: volz@cisco.com

Full Copyright Statement

   Copyright (C) The Internet Society (2006).

   This document is subject to the rights, licenses and restrictions
   contained in BCP 78, and except as set forth therein, the authors
   retain all their rights.

   This document and the information contained herein are provided on an
   "AS IS" basis and THE CONTRIBUTOR, THE ORGANIZATION HE/SHE REPRESENTS
   OR IS SPONSORED BY (IF ANY), THE INTERNET SOCIETY AND THE INTERNET
   ENGINEERING TASK FORCE DISCLAIM ALL WARRANTIES, EXPRESS OR IMPLIED,
   INCLUDING BUT NOT LIMITED TO ANY WARRANTY THAT THE USE OF THE
   INFORMATION HEREIN WILL NOT INFRINGE ANY RIGHTS OR ANY IMPLIED
   WARRANTIES OF MERCHANTABILITY OR FITNESS FOR A PARTICULAR PURPOSE.

Intellectual Property

   The IETF takes no position regarding the validity or scope of any
   Intellectual Property Rights or other rights that might be claimed to
   pertain to the implementation or use of the technology described in
   this document or the extent to which any license under such rights
   might or might not be available; nor does it represent that it has
   made any independent effort to identify any such rights.  Information
   on the procedures with respect to rights in RFC documents can be
   found in BCP 78 and BCP 79.

   Copies of IPR disclosures made to the IETF Secretariat and any
   assurances of licenses to be made available, or the result of an
   attempt made to obtain a general license or permission for the use of
   such proprietary rights by implementers or users of this
   specification can be obtained from the IETF on-line IPR repository at
   http://www.ietf.org/ipr.

   The IETF invites any interested party to bring to its attention any
   copyrights, patents or patent applications, or other proprietary
   rights that may cover technology that may be required to implement
   this standard.  Please address the information to the IETF at
   ietf-ipr@ietf.org.

Acknowledgement

   Funding for the RFC Editor function is provided by the IETF
   Administrative Support Activity (IASA).

 

User Contributions:

Comment about this RFC, ask questions, or add new information about this topic: