Are you an expert in this area? Share your knowledge and earn expert points by giving answers or rating people's questions and answers! This section of FAQS.ORG is not sanctioned in any way by FAQ authors or maintainers.

Questions strongly related to this FAQ:

• How different are the motors used in a ceiling fan and that used in a table fan...coz... by andy_anand (2/24/2004)
• how to refinish hard wood floors by doug (5/21/2004)
• For small(fractional Power) Electric Motor can the no load current exceed the Full load... by Sourav (11/6/2003)
• How much heat does a 5 hp motor develop when it is running at full load? by Mike (2/17/2004)
• What happens if AC is applied to the input of a DC motor  ? by HAI (1/5/2004)
• I have a speedair 3 HP compressor. I need to change the voltage from 220 to 110. The... by Bill Phillips (1/11/2004)
• Why the relay protection does not trip when the induction motor failure? It was trip... by Texasss (5/15/2006)
• Does anyone have a useful rule, or diagram for converting a 115V motor to 230v.  Than... by Robert (5/8/2004)
• IS THERE A ROUTER BIT TO MAKE A STEMWARE RACK OR DO I USE SOMETHING ELSE by NEIL (2/15/2007)
• I need help in reading the parameters for my induction machine as below: 50hp, 490 volts... by desperate (3/17/2007)
• 2hp direct drive table saw motor hums but does not start. Why? by proctorjr1 (3/20/2006)
• I was working my disc& belt sander when the revs. suddenly dropped by half. the motor was... by Terry (6/30/2007)
• A 6kW, 380V three phase induction motor of 0.96 power factor is udes to run a certain... by Dhammika (8/29/2003)
• i want to make an electric cycle than how can i know tht how much rating dc motor i used,... by rocky (8/4/2004)
• thank you first pleas can you give us the following : 1- what is the types of starting... by akrem (9/10/2003)
• why is it impossible for an induction motor to operate at synchronous speed by graze (4/15/2007)
• a)   Why is it impossible for an induction motor to operate at synchronous speed? b)... by amuchilani (4/12/2007)
• Why does my motor on my Mastercool swamp cooler run on high speed and not on low speed?... by James H. Norman (6/14/2004)

Questions somewhat related to this FAQ:

• What happen when induction motor is running under "NO LOAD" condition after the load is... by saravanan (6/1/2006)
• What happen when the motor is running in a "NO LOAD" condition after the load has been... by saravanan (6/1/2006)
• I would like to know the difference between a 50htz electric pump and a 60htz electric... by Mike (6/23/2006)
• i need a wiring diagram how to wired a drum switch with a single phase motor.My motor is ... by roger (4/20/2004)
• where can i find load mechanical characteristics curves on the net for the electric... by neo_21181 (12/28/2003)
• Why main winding of single phase induction motor is distributed only 2/3 part of the... by Bhadoria (12/24/2005)
• I have a 1/2 hp condenser motor with dual speeds high low.On the box it tells me 10mfd... by Sparky (3/6/2004)

Other questions awaiting answers:

• 42276 questions related to other FAQs
  
• 6426 general questions
• 15001 answered questions