Search the FAQ Archives

3 - A - B - C - D - E - F - G - H - I - J - K - L - M
N - O - P - Q - R - S - T - U - V - W - X - Y - Z
faqs.org - Internet FAQ Archives

Electrical Wiring FAQ (Part 2 of 2)
Section - How to wire 3-way and 4-way switches

( Part1 - Part2 - Single Page )
[ Usenet FAQs | Web FAQs | Documents | RFC Index | Counties ]


Top Document: Electrical Wiring FAQ (Part 2 of 2)
Previous Document: News Headers
Next Document: What kind of outlets do I need in a kitchen?
See reader questions & answers on this topic! - Help others by sharing your knowledge

	http://homewiring.tripod.com

	The above is a truly excellent site with pictures and very
	detailed code analysis.  Warning, it's NEC-only-specific.
	So, if you're outside of the USA, you will need to be careful.
	For example, the rules for kitchens are considerably different
	in Canada.

User Contributions:

1
Dev
⚠
In a fire protection circuit, circuts are shown witha no example 6,8,4etc. what it mean?these circuits are connected between smode detector,junction box etc
2
kevin
⚠
My daughter dropped a small necklace behind her dresser. The necklace crossed a plug terminal and shorted the receptacle.
I bought a new receptacle and installed the same. I still have no power I suspect there could be a bigger problem,this is aluminum wiring.
I've killed the breaker and call an electrician but am curious as to what happened.P.s. there is a dimmer switch on the same circuit.
3
dennis
⚠
Regarding new construction wiring and running 12/2 and 14/3 wire in the same box.

I have multiple switches to lights. Ran 12/2 and 14/3 into switch box and inspector wrote correction needed.

What should I have done instead?

thank you
dennis
4
Robert
⚠
Does a grounding electrode facilitate the operation of a OCPD, to clear a ground fault ?
5
@dennis
⚠
Assuming you are installing two switches in a two switch box, you probably should have used 14/2 and 14/3 instead of replacing 14/2 with 12/2. If you are only installing one switch in a one switch box, you should only have one cable in the box.
6
P k
⚠
I prefer to use nothing smaller than12 awg /the smallest sized wire on a circuit determines the allowable ampacity
Ex: 15 amp-14awg. 12awg-20amp only rule for thumb other factors such as continuous load,heating and others if you do not know the safe NEC rules then please call a qualified journeyman Electrician better be safe

Comment about this article, ask questions, or add new information about this topic:



Top Document: Electrical Wiring FAQ (Part 2 of 2)
Previous Document: News Headers
Next Document: What kind of outlets do I need in a kitchen?

Part1 - Part2 - Single Page

[ Usenet FAQs | Web FAQs | Documents | RFC Index ]

Send corrections/additions to the FAQ Maintainer:
clewis@ferret.ocunix.on.ca (Chris Lewis)




Last Update March 27 2014 @ 02:11 PM