Search the FAQ Archives

3 - A - B - C - D - E - F - G - H - I - J - K - L - M
N - O - P - Q - R - S - T - U - V - W - X - Y - Z
faqs.org - Internet FAQ Archives

Electrical Wiring FAQ (Part 2 of 2)
News Headers

( Part1 - Part2 - Single Page )
[ Usenet FAQs | Web FAQs | Documents | RFC Index | Neighborhoods ]


Top Document: Electrical Wiring FAQ (Part 2 of 2)
Next Document: How to wire 3-way and 4-way switches

Posted-By: auto-faq 3.3.1 (Perl 5.006)
Archive-name: electrical-wiring/part2


User Contributions:

Dev
Report this comment as inappropriate
Dec 21, 2011 @ 12:00 am
In a fire protection circuit, circuts are shown witha no example 6,8,4etc. what it mean?these circuits are connected between smode detector,junction box etc
kevin
Report this comment as inappropriate
Dec 24, 2011 @ 12:12 pm
My daughter dropped a small necklace behind her dresser. The necklace crossed a plug terminal and shorted the receptacle.
I bought a new receptacle and installed the same. I still have no power I suspect there could be a bigger problem,this is aluminum wiring.
I've killed the breaker and call an electrician but am curious as to what happened.P.s. there is a dimmer switch on the same circuit.
dennis
Report this comment as inappropriate
Feb 24, 2012 @ 11:11 am
Regarding new construction wiring and running 12/2 and 14/3 wire in the same box.

I have multiple switches to lights. Ran 12/2 and 14/3 into switch box and inspector wrote correction needed.

What should I have done instead?

thank you
dennis
Robert
Report this comment as inappropriate
Nov 26, 2012 @ 9:21 pm
Does a grounding electrode facilitate the operation of a OCPD, to clear a ground fault ?
@dennis
Report this comment as inappropriate
Mar 18, 2013 @ 10:10 am
Assuming you are installing two switches in a two switch box, you probably should have used 14/2 and 14/3 instead of replacing 14/2 with 12/2. If you are only installing one switch in a one switch box, you should only have one cable in the box.
P k
Report this comment as inappropriate
Jan 26, 2014 @ 10:10 am
I prefer to use nothing smaller than12 awg /the smallest sized wire on a circuit determines the allowable ampacity
Ex: 15 amp-14awg. 12awg-20amp only rule for thumb other factors such as continuous load,heating and others if you do not know the safe NEC rules then please call a qualified journeyman Electrician better be safe

Comment about this article, ask questions, or add new information about this topic:

CAPTCHA




Top Document: Electrical Wiring FAQ (Part 2 of 2)
Next Document: How to wire 3-way and 4-way switches

Part1 - Part2 - Single Page

[ Usenet FAQs | Web FAQs | Documents | RFC Index ]

Send corrections/additions to the FAQ Maintainer:
clewis@ferret.ocunix.on.ca (Chris Lewis)





Last Update March 27 2014 @ 02:11 PM