Search the FAQ Archives

3 - A - B - C - D - E - F - G - H - I - J - K - L - M
N - O - P - Q - R - S - T - U - V - W - X - Y - Z
faqs.org - Internet FAQ Archives

comp.sys.hp.hpux FAQ
Section - 8.23 Why does HP-UX 10 generate copious "Sti_save" syslog messages?

( Single Page )
[ Usenet FAQs | Web FAQs | Documents | RFC Index | Neighborhoods ]


Top Document: comp.sys.hp.hpux FAQ
Previous Document: 8.22 Is it OK to change root's shell?
Next Document: 8.24 How can I tell which kernel was booted?
See reader questions & answers on this topic! - Help others by sharing your knowledge
Updated: 04/05/01

HP-UX 10 generates a FLOOD of syslog messages that look like this:
   vmunix: Warning! [82194698 ticks since boot] Sti_save:IteLock not...
   ...available for 60 seconds

From what I can gather, these are spurious messages than can be ignored.

One way to turn them off (any suggestions for others?) is to uncomment
the "Dtlogin@grabServer:  False" line in {/usr,/etc}/dt/config/Xconfig.

After this, reset CDE (see question 4.15.2), and you won't see 'em again!

User Contributions:

Comment about this article, ask questions, or add new information about this topic:

CAPTCHA




Top Document: comp.sys.hp.hpux FAQ
Previous Document: 8.22 Is it OK to change root's shell?
Next Document: 8.24 How can I tell which kernel was booted?

Single Page

[ Usenet FAQs | Web FAQs | Documents | RFC Index ]

Send corrections/additions to the FAQ Maintainer:
hpux.faq@gmail.com





Last Update March 27 2014 @ 02:11 PM