RFC 3429 - Assignment of the 'OAM Alert Label' for Multiprotocol
Network Working Group H. Ohta Request for Comments: 3429 NTT Category: Informational November 2002 Assignment of the 'OAM Alert Label' for Multiprotocol Label Switching Architecture (MPLS) Operation and Maintenance (OAM) Functions Status of this Memo This memo provides information for the Internet community. It does not specify an Internet standard of any kind. Distribution of this memo is unlimited. Copyright Notice Copyright (C) The Internet Society (2002). All Rights Reserved. Abstract This document describes the assignment of one of the reserved label values defined in RFC 3032 (MPLS label stack encoding) to the 'Operation and Maintenance (OAM) Alert Label' that is used by user- plane Multiprotocol Label Switching Architecture (MPLS) OAM functions for identification of MPLS OAM packets. 1. Introduction This document describes the assignment of one of the reserved label values defined in RFC 3032 (MPLS label stack encoding ) to the 'OAM Alert Label' that is used by user-plane MPLS OAM functions for identification of MPLS OAM packets as described in the ITU-T Recommendation Y.1711  (on MPLS OAM functions). 2. OAM functions MPLS OAM (Operation and Maintenance) functions provide necessary tools for network operators to operate and maintain the networks. MPLS OAM functionality is required at the MPLS layer, and more specifically at each MPLS level, independent of OAM functionality provided by the lower layers (SONET/SDH, etc.). The objectives of the OAM functions include the following: - Defect and failure detection: Defect/failures affecting the transport of user information are detected by continuous or periodic checking. As a result, maintenance event information or appropriate alarms will be produced. - Reporting the defect/failure information: Defect information is given to other management entities (e.g., Operation Support System) in order to provide the appropriate indications to the maintenance staff for maintaining the Quality of Service (QoS) level offered to customers. - Defect/failure localization: Determination by internal or external test systems of a failed entity is performed if defect information is insufficient. - Performance monitoring: Performance (packet losses, transfer delay, bit errors, etc.) of the user information transport is measured in order to estimate the transport integrity. 3. OAM Packet Identification The user-plane MPLS OAM mechanisms as described in the ITU-T Recommendation Y.1711  uses a special label called 'OAM Alert Label' to differentiate OAM packets from the normal user packets. One of the reserved label values defined in RFC 3032 (MPLS label stack encoding ) is assigned to 'OAM Alert Label'. A value of 14 is used for this purpose. 4. MPLS OAM work in ITU-T SG13 ITU-T Study Group 13, Question 3/13 is progressing work on user-plane MPLS OAM and has produced the following documents: (1) Recommendation Y.1710 (Requirements for OAM functionality for MPLS networks)  (2) Corrigendum 1 to Recommendation Y.1710  (3) Recommendation Y.1711 (OAM mechanisms for MPLS networks)  (4) Draft Recommendation Y.1720 (Protection switching for MPLS networks)  relies on OAM mechanisms in Y.1711, under last call as of Nov. 2002. 5. Considerations on penultimate hop popping (PHP) In response to concerns raised during IETF meetings and in related discussions, this section provides an explanation on how MPLS OAM functions defined in ITU-T Recommendation Y.1711  are applied to MPLS networks where PHP is in effect. 5.1 Scope of ITU-T Recommendation Y.1711 The scope of ITU-T Recommendation Y.1711 includes application to both non-PHP and PHP cases as quoted below . "1 Scope This Recommendation provides mechanisms for user-plane OAM (Operation and Maintenance) functionality in MPLS networks according to the requirements and principles given in Recommendation Y.1710. OAM functions specified in this Recommendation can be applied to both non-PHP and PHP cases unless otherwise stated. The current version of this recommendation is designed primarily to support point-to-point and multipoint-to-point explicit routed LSPs (ER-LSPs)." 5.2 Applicability of MPLS OAM to PHP There are two cases where PHP is used: Case 1: The ultimate node is an MPLS LSR, and implements both MPLS control-plane and data-plane, but is not able to perform 2 lookups at line rate. So it asks the penultimate node to pop the top label (rather than swapping it), using the MPLS reserved label 3 (implicit null label) as per defined in RFC 3032 . Case 2: The ultimate node has no MPLS label look up and processing capability and does not recognize labeled packets. This node asks for PHP, using the MPLS reserved label 3 (implicit null label) as defined in RFC 3032 . Currently, MPLS OAM functions defined in ITU-T Recommendation Y.1711  can only be applied to Case 1. The next subsection describes the node behavior in Case 1. Application for Case 2 needs further study. Also, application to carrier supporting carrier scenarios is for future study. 5.3 Node behavior when OAM functions are activated Where the ultimate LSR is an MPLS LSR and PHP is in effect, the penultimate LSR pops the top label and forwards the OAM packet (with the OAM label and the OAM payload intact) to the ultimate LSR . - If the ultimate LSR supports MPLS OAM, it understands that a received packet with an OAM label on top is an OAM packet, since the original top label has been removed by the penultimate LSR. It also knows the ingress LSR that originated the MPLS OAM packet from the TTSI (Trail Termination Source Identifier) value of the received MPLS OAM packet. TTSI is a unique identifier for ingress LSR that is contained in MPLS OAM packets (see ITU-T Recommendation Y.1711 ). - If the ultimate LSR does not support MPLS OAM, the OAM packet is discarded as per section 3.18 of RFC 3031 . 6. IANA Considerations The IANA has reserved the use of the MPLS label value of 14 as the 'OAM Alert Label'. See section 3 for additional information. 7. Security Considerations This document does not raise any security issues that are not already present in either the MPLS architecture or in the architecture of the network layer protocol contained within the encapsulation. OAM functions could enhance the security of MPLS networks. For example, Connectivity Verification (CV) function defined in ITU-T Recommendation Y.1711  can detect mis-connections, and therefore can prevent customers' traffic being exposed to other customers. 8. Acknowledgements The author wishes to thank Shahram Davari with PMC-Sierra, Neil Harrison with British Telecom, Monique Morrow, Thomas D. Nadeau, Hari Rakotoranto and Chip Sharp with Cisco Systems, Khalid Ahmad and David Allan with Nortel Networks, and Mina Azad with Azad-Mohtaj Consulting for their valuable contributions and discussions. 9. Normative References  ITU-T Recommendation Y.1711, "OAM mechanism for MPLS networks", November 2002.  Rosen, E., Tappan, D., Fedorkow, G., Rekhter, Y., Farinaccia, D., Li, T. and A. Conta, "MPLS label stack encoding", RFC 3032, January 2001.  ITU-T recommendation Y.1710, "Requirements for OAM functionality for MPLS networks" July 2001.  ITU-T Corrigendum 1 to Recommendation Y.1710, November 2002.  Rosen, E., Viswanathan, A. and R. Callon, "Multiprotocol Label Switching Architecture", RFC 3031, January 2001. 10. Informative Reference  ITU-T Draft Recommendation Y.1720, "Protection switching for MPLS networks", under last call as of November 2002. 11. Author's Address Hiroshi OHTA NTT 3-9-11 Midori-Cho, Musashino-Shi Tokyo 180-8585 Japan Phone: +81 422 59 3617 Fax: +81 422 59 3787 EMail: firstname.lastname@example.org 12. Full Copyright Statement Copyright (C) The Internet Society (2002). All Rights Reserved. This document and translations of it may be copied and furnished to others, and derivative works that comment on or otherwise explain it or assist in its implementation may be prepared, copied, published and distributed, in whole or in part, without restriction of any kind, provided that the above copyright notice and this paragraph are included on all such copies and derivative works. However, this document itself may not be modified in any way, such as by removing the copyright notice or references to the Internet Society or other Internet organizations, except as needed for the purpose of developing Internet standards in which case the procedures for copyrights defined in the Internet Standards process must be followed, or as required to translate it into languages other than English. The limited permissions granted above are perpetual and will not be revoked by the Internet Society or its successors or assigns. This document and the information contained herein is provided on an "AS IS" basis and THE INTERNET SOCIETY AND THE INTERNET ENGINEERING TASK FORCE DISCLAIMS ALL WARRANTIES, EXPRESS OR IMPLIED, INCLUDING BUT NOT LIMITED TO ANY WARRANTY THAT THE USE OF THE INFORMATION HEREIN WILL NOT INFRINGE ANY RIGHTS OR ANY IMPLIED WARRANTIES OF MERCHANTABILITY OR FITNESS FOR A PARTICULAR PURPOSE. Acknowledgement Funding for the RFC Editor function is currently provided by the Internet Society.