...DROP A BOSS 800X2 CHANNEL AMP DOWN TO 1 OHM STABLE...

<< Back to: rec.audio.car FAQ (Part 5/5)

FAQS.ORG makes no guarantees as to the accuracy of the posts. Each post is the personal opinion of the poster. These posts are not intended to substitute for medical, tax, legal, investment, accounting, or other professional advice. FAQS.ORG does not endorse any opinion or any product or service mentioned mentioned in these posts.

<< Back to: rec.audio.car FAQ (Part 5/5)

[ Home | FAQ-Related Q&As | General Q&As | Answered Questions ]

Question by Music Creator
Submitted on 10/27/2003
Related FAQ: rec.audio.car FAQ (Part 5/5)
Rating:	Rate this question:
HOW DO I DROP A BOSS 800X2 CHANNEL AMP DOWN TO 1 OHM STABLE PLEASE HELP ME

Answer by tot
Submitted on 12/4/2003
Rating:	Rate this answer:
that is impossible!!!

Answer by T
Submitted on 2/17/2004
Rating: Not yet rated	Rate this answer:
bridge it and run it in a circuit

Answer by old-school
Submitted on 3/23/2004
Rating:	Rate this answer:
Your Ohm load is determined by your resistance (speakers in this case). If you are familiar with electronics you need to run four 4 ohm speakers in parallel to achieve 1 ohm. Parallel is equvalent to "splicing" a wire. To determine the total load (Ohm load) you add the recipricals of the loads and recipricate the answer. Example four 4 ohm speakers (1/4 + 1/4 = 1/2 , recipricated to 2/1 or 2 ohms.) That is why dual voice coils are popular. You can have two Dual Voice Coil Speakers have a total load of 1 ohm (all voice coils in parallel).

Answer by 03BLAZER
Submitted on 6/21/2006
Rating: Not yet rated	Rate this answer:
HEY I DON'T REALLY UNDERSTAND WHAT YOU MEAN BY THAT BUT MAYBE YOU CAN TELL ME HOW I CAN WIRE MY 2 OHM KICKER SOLOBARICKS TO A 1 OHM LOAD??????

Answer by Underlord_69
Submitted on 7/21/2006
Rating: Not yet rated	Rate this answer:
Make sure your amp is rated for 1 ohm stable load most boss amps can't handle such low resistance or you will blow your amp

Answer by HOMO
Submitted on 3/31/2007
Rating: Not yet rated	Rate this answer:
YOU LOADF OF A GAYS

Answer by XsSPL
Submitted on 4/27/2007
Rating: Not yet rated	Rate this answer:
Boss Audio is trash you could make it run @ 1 ohm for about 0.00001 seconds then it would smoke. Low impedance loads require serious MOSFETs which= serious $. Just the wiring for a system than can run @ 1 ohm safely probably costs more than your amp did.

Your name or nickname:
If you'd like to create a new account or access your existing account, put in your password here:
Your answer: