[ Home  |  FAQ-Related Q&As  |  General Q&As  |  Answered Questions ]

    Search the Q&A Archives

i have a new 318 engine , it came with timing gears and...

<< Back to: rec.autos.makers.chrysler FAQ, Part 1/6

Question by weirdharold
Submitted on 7/3/2006
Related FAQ: rec.autos.makers.chrysler FAQ, Part 1/6
Rating: Not yet rated Rate this question: Vote
i have a new 318 engine , it came with timing gears and chain installed.we had #1 piston tdc and installed the harmonic balancer with the timing marks showing tdc.the engine runs good but when we put a timing light on it  the mark on the harmonic are 180 out.we put the light on #1 plug wire and that was the results.how can this be?when we hooked the light to # 8 wire  we could barely see the mark on the bottom.  HELP!!!


Your answer will be published for anyone to see and rate.  Your answer will not be displayed immediately.  If you'd like to get expert points and benefit from positive ratings, please create a new account or login into an existing account below.


Your name or nickname:
If you'd like to create a new account or access your existing account, put in your password here:
Your answer:

FAQS.ORG reserves the right to edit your answer as to improve its clarity.  By submitting your answer you authorize FAQS.ORG to publish your answer on the WWW without any restrictions. You agree to hold harmless and indemnify FAQS.ORG against any claims, costs, or damages resulting from publishing your answer.

 

FAQS.ORG makes no guarantees as to the accuracy of the posts. Each post is the personal opinion of the poster. These posts are not intended to substitute for medical, tax, legal, investment, accounting, or other professional advice. FAQS.ORG does not endorse any opinion or any product or service mentioned mentioned in these posts.

 

<< Back to: rec.autos.makers.chrysler FAQ, Part 1/6

[ Home  |  FAQ-Related Q&As  |  General Q&As  |  Answered Questions ]
© 2008 FAQS.ORG. All rights reserved.