I need to replace the hall sender on my 94 vr6 Passat. could...

<< Back to: rec.autos.vw [W] TECHNICAL, FREQUENTLY ASKED QUESTION (FAQ)

FAQS.ORG makes no guarantees as to the accuracy of the posts. Each post is the personal opinion of the poster. These posts are not intended to substitute for medical, tax, legal, investment, accounting, or other professional advice. FAQS.ORG does not endorse any opinion or any product or service mentioned mentioned in these posts.

<< Back to: rec.autos.vw [W] TECHNICAL, FREQUENTLY ASKED QUESTION (FAQ)

[ Home | FAQ-Related Q&As | General Q&As | Answered Questions ]

Question by RJ
Submitted on 5/28/2004
Related FAQ: rec.autos.vw [W] TECHNICAL, FREQUENTLY ASKED QUESTION (FAQ)
Rating:	Rate this question:
I need to replace the hall sender on my 94 vr6 Passat. could you please inform me of it's location on the engine.

Answer by wugorek@freenet.de
Submitted on 7/9/2006
Rating: Not yet rated	Rate this answer:
Its up there where the six kabels for the high voltage go from. The hall sender tells the Motorcomputer when the upper deadpoint of the motor is reached. so do we call this here in germany. the exact position of the turning of the motor is told from down at the block where the speed-sensor controls the rotation of the "antriebswelle". there are also two sensors at the block for the front and the rear cylinder-row which control the point of ignition and expolosion in each of the two cylinderrows.

Answer by pyro_the_pyromaniac
Submitted on 9/10/2006
Rating: Not yet rated	Rate this answer:
Uh it's in the distributer! Duh!

Your name or nickname:
If you'd like to create a new account or access your existing account, put in your password here:
Your answer: