[ Home  |  FAQ-Related Q&As  |  General Q&As  |  Answered Questions ]

    Search the Q&A Archives

I have an aha 2940uw with a seagate st118202lc loaded with...

<< Back to: comp.periphs.scsi FAQ part 1 of 2

Question by chitech
Submitted on 4/1/2004
Related FAQ: comp.periphs.scsi FAQ part 1 of 2
Rating: Rate this question: Vote
I have an aha 2940uw with a seagate st118202lc loaded with xp pro on a biostar m7ncd mb.I am using a 68 pin cable with a built in terminator.My card termination is set to low=on and high=on.My problem is my os will not boot from a power up but it loads fine on warm resets.Can anyone help.Thanks


Answer by MArk
Submitted on 12/25/2004
Rating: Not yet rated Rate this answer: Vote
Set Power on delay jumper = "no Delay" (On the hard drive)

 

Your answer will be published for anyone to see and rate.  Your answer will not be displayed immediately.  If you'd like to get expert points and benefit from positive ratings, please create a new account or login into an existing account below.


Your name or nickname:
If you'd like to create a new account or access your existing account, put in your password here:
Your answer:

FAQS.ORG reserves the right to edit your answer as to improve its clarity.  By submitting your answer you authorize FAQS.ORG to publish your answer on the WWW without any restrictions. You agree to hold harmless and indemnify FAQS.ORG against any claims, costs, or damages resulting from publishing your answer.

 

FAQS.ORG makes no guarantees as to the accuracy of the posts. Each post is the personal opinion of the poster. These posts are not intended to substitute for medical, tax, legal, investment, accounting, or other professional advice. FAQS.ORG does not endorse any opinion or any product or service mentioned mentioned in these posts.

 

<< Back to: comp.periphs.scsi FAQ part 1 of 2

[ Home  |  FAQ-Related Q&As  |  General Q&As  |  Answered Questions ]
© 2008 FAQS.ORG. All rights reserved.