[ Home  |  FAQ-Related Q&As  |  General Q&As  |  Answered Questions ]

    Search the Q&A Archives

I have a Ajax Horizon Horizon positioner on a 10' mesh dish....

<< Back to general questions

Question by Onie
Submitted on 7/30/2003
Related FAQ: N/A
Rating: Rate this question: Vote
I have a Ajax Horizon Horizon positioner on a 10' mesh dish.  I recently began having problems with my positioner being accurate on counting.  My serviceman said I needed to replace the old mechanical switch with magnetic reed switch.  I am able to get part of the magnetic switch, the reed itself, but am unable to get the magnet wheel.  Does anybody have any ideas?  I've done a lot of searching but no luck.  I sure hate to have to replace that positioner because of a switch.


Your answer will be published for anyone to see and rate.  Your answer will not be displayed immediately.  If you'd like to get expert points and benefit from positive ratings, please create a new account or login into an existing account below.


Your name or nickname:
If you'd like to create a new account or access your existing account, put in your password here:
Your answer:

FAQS.ORG reserves the right to edit your answer as to improve its clarity.  By submitting your answer you authorize FAQS.ORG to publish your answer on the WWW without any restrictions. You agree to hold harmless and indemnify FAQS.ORG against any claims, costs, or damages resulting from publishing your answer.

 

FAQS.ORG makes no guarantees as to the accuracy of the posts. Each post is the personal opinion of the poster. These posts are not intended to substitute for medical, tax, legal, investment, accounting, or other professional advice. FAQS.ORG does not endorse any opinion or any product or service mentioned mentioned in these posts.

 

<< Back to general questions

[ Home  |  FAQ-Related Q&As  |  General Q&As  |  Answered Questions ]
© 2008 FAQS.ORG. All rights reserved.