[ Home  |  FAQ-Related Q&As  |  General Q&As  |  Answered Questions ]

    Search the Q&A Archives

...change the PIO mode to 4. speed up the...

<< Back to: Enhanced IDE/Fast-ATA/ATA-2 FAQ [1 of 2]

Question by Royal
Submitted on 1/17/2004
Related FAQ: Enhanced IDE/Fast-ATA/ATA-2 FAQ [1 of 2]
Rating: Rate this question: Vote
How to change the PIO mode to 4.
How to speed up the transfer rate..
Is the IORDY may be used and how to control the operation flow..
eq.
write Device/head reg.
write sector count reg.
write command reg.
and how about the operation of IORDY pin must to be setup

Thank you very much!!



Answer by fgfgdfg
Submitted on 8/17/2006
Rating: Not yet rated Rate this answer: Vote
in your bios somewhere

 

Your answer will be published for anyone to see and rate.  Your answer will not be displayed immediately.  If you'd like to get expert points and benefit from positive ratings, please create a new account or login into an existing account below.


Your name or nickname:
If you'd like to create a new account or access your existing account, put in your password here:
Your answer:

FAQS.ORG reserves the right to edit your answer as to improve its clarity.  By submitting your answer you authorize FAQS.ORG to publish your answer on the WWW without any restrictions. You agree to hold harmless and indemnify FAQS.ORG against any claims, costs, or damages resulting from publishing your answer.

 

FAQS.ORG makes no guarantees as to the accuracy of the posts. Each post is the personal opinion of the poster. These posts are not intended to substitute for medical, tax, legal, investment, accounting, or other professional advice. FAQS.ORG does not endorse any opinion or any product or service mentioned mentioned in these posts.

 

<< Back to: Enhanced IDE/Fast-ATA/ATA-2 FAQ [1 of 2]

[ Home  |  FAQ-Related Q&As  |  General Q&As  |  Answered Questions ]
© 2008 FAQS.ORG. All rights reserved.