United States International Trade Commision Rulings And Harmonized Tariff Schedule
faqs.org  Rulings By Number  Rulings By Category  Tariff Numbers
faqs.org > Rulings and Tariffs Home > Rulings By Number > 1999 NY Rulings > NY E84956 - NY E85009 > NY E84990

Previous Ruling Next Ruling
NY E84990





October 8, 1999

CLA-2-39:RR:NC:2:237 E84990

CATEGORY: CLASSIFICATION

TARIFF NO.: 4002.99.0000

Ms. Gail T. Cumins
Sharretts, Paley, Carter & Blauvelt, P.C. Seventy-five Broad Street
New York, N.Y. 10004

RE: The tariff classification of a polypropylene modified rubber from Japan.

Dear Ms. Cumins:

In your letter dated July 22, 1999, on behalf of Sumitomo Chemical America, Inc., you requested a tariff classification ruling.

The product designated TPE WTZ293MB is described as a plastic modified EPDM (ethylene-propylene-diene-monomer), rubber consisting predominately of EDPM and a lesser amount of polypropylene.

Classification of merchandise under the Harmonized Tariff Schedule of the United States, (HTS), is governed by the General Rules of Interpretation (GRI’s). GRI 1 provides that classification is determined first in accordance with the terms of the headings of the tariff and any relative section or chapter notes, and unless otherwise required, according to the remaining GRI’s taken in order.

Heading 4002, HTS, provides for other synthetic rubber and factice derived from oils, in primary forms or in plates, sheets or strip. Subheading 4002.70.0000, HTS, provides for ethylene-propylene-non-conjugated-diene rubber (EPDM). EDPM denotes an unsaturated terpolymer based on the three monomers: ethylene, propylene and a non-conjugated diene. However, the instant product, TPE WT293MB, is a plastic modified rubber, where EPDM is the main component, a terpolymer modified with polypropylene. Based on Explanatory Note 40.02(4)(c)(3) this heading covers mixtures of unsaturated synthetic substances with saturated synthetic high polymers. Other synthetic rubbers in primary forms are provided for in subheading 4002.99.0000, HTS.

Note 4(a) is relevant to articles which may fall under Heading 4002. Note 4(a) provides that the expression “synthetic rubber” applies to: Unsaturated synthetic substances which can be irreversibly transformed by vulcanization with sulfur into non-thermoplastic substances which, at a temperature between 18 degrees centigrade and 29 degrees centigrade, will not break on being extended to three times their original length and will return, after being extended to twice their original length, within a period of 5 minutes, to a length not greater than 1-1/2 times their original length, For the purposes of this test, substances necessary for the cross-linking, such as vulcanizing activators or accelerators, may be added; the presence of substances as provided for by note 5(b)(ii) and (iii) is also permitted. However, the presence of any substances not necessary for the cross-linking, such as extenders, plasticizers and fillers, is not permitted.

Based on the elongation and recovery test results you furnished from Sumitomo Chemical America, Inc., and the dumbbell samples you submitted the product appears to meet the requirements of Note 4(a).

Based on the foregoing, the applicable subheading for TPE WT293MB polypropylene modified EPDM, will be 4002.99.0000, Harmonized Tariff Schedule of the United States (HTS), which provides for other synthetic rubber and factice derived from oils, in primary forms or in plates, sheets or strip. The rate of duty is free.

This merchandise may be subject to the requirements of the Toxic Substances Control Act (TSCA), which is administered by the U.S. Environmental Protection Agency. You may contact them at 402 M Street, S.W., Washington, D.C. 20460, telephone number (202) 554-1404 or EPA Region II at (908) 321-6669.

This ruling is being issued under the provisions of Part 177 of the Customs Regulations (19 C.F.R. 177).

A copy of the ruling or the control number indicated above should be provided with the entry documents filed at the time this merchandise is imported. If you have any questions regarding the ruling, contact National Import Specialist Frank Cantone at 212-637-7018.

Sincerely,

Robert B. Swierupski
Director,

Previous Ruling Next Ruling

See also: