faqs.org - Internet FAQ Archives

RFC 3514 - The Security Flag in the IPv4 Header


Or Display the document by number




Network Working Group                                        S. Bellovin
Request for Comments: 3514                            AT&T Labs Research
Category: Informational                                     1 April 2003

                  The Security Flag in the IPv4 Header

Status of this Memo

   This memo provides information for the Internet community.  It does
   not specify an Internet standard of any kind.  Distribution of this
   memo is unlimited.

Copyright Notice

   Copyright (C) The Internet Society (2003).  All Rights Reserved.

Abstract

   Firewalls, packet filters, intrusion detection systems, and the like
   often have difficulty distinguishing between packets that have
   malicious intent and those that are merely unusual.  We define a
   security flag in the IPv4 header as a means of distinguishing the two
   cases.

1. Introduction

   Firewalls [CBR03], packet filters, intrusion detection systems, and
   the like often have difficulty distinguishing between packets that
   have malicious intent and those that are merely unusual.  The problem
   is that making such determinations is hard.  To solve this problem,
   we define a security flag, known as the "evil" bit, in the IPv4
   [RFC791] header.  Benign packets have this bit set to 0; those that
   are used for an attack will have the bit set to 1.

1.1. Terminology

   The keywords MUST, MUST NOT, REQUIRED, SHALL, SHALL NOT, SHOULD,
   SHOULD NOT, RECOMMENDED, MAY, and OPTIONAL, when they appear in this
   document, are to be interpreted as described in [RFC2119].

2. Syntax

   The high-order bit of the IP fragment offset field is the only unused
   bit in the IP header.  Accordingly, the selection of the bit position
   is not left to IANA.

   The bit field is laid out as follows:

             0
            +-+
            |E|
            +-+

   Currently-assigned values are defined as follows:

   0x0  If the bit is set to 0, the packet has no evil intent.  Hosts,
        network elements, etc., SHOULD assume that the packet is
        harmless, and SHOULD NOT take any defensive measures.  (We note
        that this part of the spec is already implemented by many common
        desktop operating systems.)

   0x1  If the bit is set to 1, the packet has evil intent.  Secure
        systems SHOULD try to defend themselves against such packets.
        Insecure systems MAY chose to crash, be penetrated, etc.

3. Setting the Evil Bit

   There are a number of ways in which the evil bit may be set.  Attack
   applications may use a suitable API to request that it be set.
   Systems that do not have other mechanisms MUST provide such an API;
   attack programs MUST use it.

   Multi-level insecure operating systems may have special levels for
   attack programs; the evil bit MUST be set by default on packets
   emanating from programs running at such levels.  However, the system
   MAY provide an API to allow it to be cleared for non-malicious
   activity by users who normally engage in attack behavior.

   Fragments that by themselves are dangerous MUST have the evil bit
   set.  If a packet with the evil bit set is fragmented by an
   intermediate router and the fragments themselves are not dangerous,
   the evil bit MUST be cleared in the fragments, and MUST be turned
   back on in the reassembled packet.

   Intermediate systems are sometimes used to launder attack
   connections.  Packets to such systems that are intended to be relayed
   to a target SHOULD have the evil bit set.

   Some applications hand-craft their own packets.  If these packets are
   part of an attack, the application MUST set the evil bit by itself.

   In networks protected by firewalls, it is axiomatic that all
   attackers are on the outside of the firewall.  Therefore, hosts
   inside the firewall MUST NOT set the evil bit on any packets.

   Because NAT [RFC3022] boxes modify packets, they SHOULD set the evil
   bit on such packets.  "Transparent" http and email proxies SHOULD set
   the evil bit on their reply packets to the innocent client host.

   Some hosts scan other hosts in a fashion that can alert intrusion
   detection systems.  If the scanning is part of a benign research
   project, the evil bit MUST NOT be set.  If the scanning per se is
   innocent, but the ultimate intent is evil and the destination site
   has such an intrusion detection system, the evil bit SHOULD be set.

4. Processing of the Evil Bit

   Devices such as firewalls MUST drop all inbound packets that have the
   evil bit set.  Packets with the evil bit off MUST NOT be dropped.
   Dropped packets SHOULD be noted in the appropriate MIB variable.

   Intrusion detection systems (IDSs) have a harder problem.  Because of
   their known propensity for false negatives and false positives, IDSs
   MUST apply a probabilistic correction factor when evaluating the evil
   bit.  If the evil bit is set, a suitable random number generator
   [RFC1750] must be consulted to determine if the attempt should be
   logged.  Similarly, if the bit is off, another random number
   generator must be consulted to determine if it should be logged
   despite the setting.

   The default probabilities for these tests depends on the type of IDS.
   Thus, a signature-based IDS would have a low false positive value but
   a high false negative value.  A suitable administrative interface
   MUST be provided to permit operators to reset these values.

   Routers that are not intended as as security devices SHOULD NOT
   examine this bit.  This will allow them to pass packets at higher
   speeds.

   As outlined earlier, host processing of evil packets is operating-
   system dependent; however, all hosts MUST react appropriately
   according to their nature.

5. Related Work

   Although this document only defines the IPv4 evil bit, there are
   complementary mechanisms for other forms of evil.  We sketch some of
   those here.

   For IPv6 [RFC2460], evilness is conveyed by two options.  The first,
   a hop-by-hop option, is used for packets that damage the network,
   such as DDoS packets.  The second, an end-to-end option, is for
   packets intended to damage destination hosts.  In either case, the

   option contains a 128-bit strength indicator, which says how evil the
   packet is, and a 128-bit type code that describes the particular type
   of attack intended.

   Some link layers, notably those based on optical switching, may
   bypass routers (and hence firewalls) entirely.  Accordingly, some
   link-layer scheme MUST be used to denote evil.  This may involve evil
   lambdas, evil polarizations, etc.

   DDoS attack packets are denoted by a special diffserv code point.

   An application/evil MIME type is defined for Web- or email-carried
   mischief.  Other MIME types can be embedded inside of evil sections;
   this permit easy encoding of word processing documents with macro
   viruses, etc.

6. IANA Considerations

   This document defines the behavior of security elements for the 0x0
   and 0x1 values of this bit.  Behavior for other values of the bit may
   be defined only by IETF consensus [RFC2434].

7. Security Considerations

   Correct functioning of security mechanisms depend critically on the
   evil bit being set properly.  If faulty components do not set the
   evil bit to 1 when appropriate, firewalls will not be able to do
   their jobs properly.  Similarly, if the bit is set to 1 when it
   shouldn't be, a denial of service condition may occur.

8. References

   [CBR03]   W.R. Cheswick, S.M. Bellovin, and A.D. Rubin, "Firewalls
             and Internet Security: Repelling the Wily Hacker", Second
             Edition, Addison-Wesley, 2003.

   [RFC791]  Postel, J., "Internet Protocol", STD 5, RFC 791, September
             1981.

   [RFC1750] Eastlake, D., 3rd, Crocker, S. and J. Schiller, "Randomness
             Recommendations for Security", RFC 1750, December 1994.

   [RFC2119] Bradner, S., "Key words for use in RFCs to Indicate
             Requirement Levels", BCP 14, RFC 2119, March 1997.

   [RFC2434] Narten, T. and H. Alvestrand, "Guidelines for Writing an
             IANA Considerations Section in RFCs", BCP 26, RFC 2434,
             October 1998.

   [RFC2460] Deering, S. and R. Hinden, "Internet Protocol, Version 6
             (IPv6) Specification", RFC 2460, December 1998.

   [RFC3022] Srisuresh, P. and K. Egevang, "Traditional IP Network
             Address Translator (Traditional NAT)", RFC 3022, January
             2001.

9. Author's Address

   Steven M. Bellovin
   AT&T Labs Research
   Shannon Laboratory
   180 Park Avenue
   Florham Park, NJ 07932

   Phone: +1 973-360-8656
   EMail: bellovin@acm.org

10. Full Copyright Statement

   Copyright (C) The Internet Society (2003).  All Rights Reserved.

   This document and translations of it may be copied and furnished to
   others, and derivative works that comment on or otherwise explain it
   or assist in its implementation may be prepared, copied, published
   and distributed, in whole or in part, without restriction of any
   kind, provided that the above copyright notice and this paragraph are
   included on all such copies and derivative works.  However, this
   document itself may not be modified in any way, such as by removing
   the copyright notice or references to the Internet Society or other
   Internet organizations, except as needed for the purpose of
   developing Internet standards in which case the procedures for
   copyrights defined in the Internet Standards process must be
   followed, or as required to translate it into languages other than
   English.

   The limited permissions granted above are perpetual and will not be
   revoked by the Internet Society or its successors or assigns.

   This document and the information contained herein is provided on an
   "AS IS" basis and THE INTERNET SOCIETY AND THE INTERNET ENGINEERING
   TASK FORCE DISCLAIMS ALL WARRANTIES, EXPRESS OR IMPLIED, INCLUDING
   BUT NOT LIMITED TO ANY WARRANTY THAT THE USE OF THE INFORMATION
   HEREIN WILL NOT INFRINGE ANY RIGHTS OR ANY IMPLIED WARRANTIES OF
   MERCHANTABILITY OR FITNESS FOR A PARTICULAR PURPOSE.

Acknowledgement

   Funding for the RFC Editor function is currently provided by the
   Internet Society.

 

User Contributions:

1
Smolani Mikfar Saba
Section 2, "Syntax": Bit ordering of the diagram is clear.This could lead to inconsistent implementation.

Comment about this RFC, ask questions, or add new information about this topic: