Neoplan Transit Bus 1987
Model Transit Bus made in 1987 by Neoplan got 2 recalls. There were some recalls concerningelectrical system, unknown or other.
Model 1987
Recalls
Campaign | Manufacturer | Manufacturing date | Type | # of units affected | Date Owner notified Mfg | Recall Initiated by | Manufacturers of recalled vehicles/products | Report Recieved Date | Record Creation Date | Regulation Part Number | FMVSS Number | |||||
---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|
ELECTRICAL SYSTEM - IGNITION - MODULE | ||||||||||||||||
92V029000 | NEOPLAN USA CORP. | from 01/01/1986 to 01/01/1991 | V (Vehicle) | 1439 | 02/14/1992 | MFR | NEOPLAN USA CORPORATION | 03/06/1992 | 03/16/1992 | |||||||
Defect Summary | Stray voltage induced on the power takeoff (pto) signal circuit 510 may occur when the electronic control module (ecm) connector gets wet, causing unintended engine acceleration. | |||||||||||||||
Consequence Summary | Unintended engine acceleration while the bus is in gearmay result in a loss of vehicle control and an accident. | |||||||||||||||
Corrective Summary | Install a ground interlock to ground circuit 510 in the ddec system anytime the pto is disabled for any reason. the ground eliminates the stray voltage effect between the ecm connector and circuit 510. | |||||||||||||||
Notes | System: electrical system.vehicle description: transit buses and inter-city coaches equipped with detroitdiesel ec-1 and ec-ii controlled 6v-92ta, 8v-92ta, and series 60 engines. | |||||||||||||||
UNKNOWN OR OTHER | ||||||||||||||||
89V205000 | NEOPLAN USA CORP. | from 04/01/1986 to 06/01/1989 | V (Vehicle) | 400 | 11/22/1989 | ODI | NEOPLAN USA CORPORATION | 11/28/1989 | 11/29/1989 | |||||||
Defect Summary | Certain bolts such as the drive shaft bolts, steering mounting bolts, motor mount bolts, and the wheel chair support bolts may not meet sae specifications. | |||||||||||||||
Consequence Summary | Bolts could break or fail affecting the specific component involved, resulting in a potential an accident and/or personal injury. | |||||||||||||||
Corrective Summary | Replace non-specification bolts with bolts that meet sae specifications. | |||||||||||||||
Notes | System: non-standard bolts.vehicle description: transit buses. |