Great Dane Trailer 1995

Model Trailer made in 1995 by Great Dane got 2 recalls. There were some recalls concerningservice brakes, air, service brakes, hydraulic.

Model 1995

Recalls


CampaignManufacturerManufacturing dateType# of units affectedDate Owner notified MfgRecall Initiated byManufacturers of recalled vehicles/productsReport Recieved DateRecord Creation DateRegulation Part NumberFMVSS Number
SERVICE BRAKES, AIR - SUPPLY - CHECK VALVE
02V210004GREAT DANE TRAILERS, INC.from 03/01/1994 to 03/31/2000V (Vehicle)MFRGREAT DANE LIMITED PARTNERSHIP08/15/200209/13/2002
Defect SummaryOn certain trailers equipped with spring brake control valve assemblies, there is a recessed area on top of the valve in which a brass guide pin fits down inside the body of the valve and is held in place by a steel snap ring. the recessed area allows accumulation of water, dirt, and/or chemicals to build up behind the snap ring to the point where it will no longer contain the guide pin resulting in a failure of the air valve.
Consequence SummaryFailure of the valve in an empty or lightly loaded trailer while the vehicle is in motion could result in a hard application of the spring brakes, possibly locking up the trailer wheels and resulting in a vehicle crash.
Corrective SummarySealco will provide a repair kit and installation instructions to its customers free of charge. owners who take their vehicles to an authorized dealer on an agreed upon service date and do not receive the free remedy within a reasonable time should contact sealco at 602-253-1007 or great dane at 912-644-2100.
NotesAlso, customers can contact the national highway traffic safety administration's auto safety hotline at 1-888-dash-2-dot (1-888-327-4236).
SERVICE BRAKES, HYDRAULIC - ANTILOCK
97V238001GREAT DANE TRAILERS, INC.from 10/01/1994 to 06/30/1996V (Vehicle)433112/12/1997MFRGREAT DANE LIMITED PARTNERSHIP12/30/199701/07/1998
Defect SummaryVehicle description: trailers equipped with antilock braking system (abs) electronic control units (ecu) for over-the-road trailer applications. the cover seal (o-ring) may have been improperly installed in certain easy-stop trailer abs electronic control units. an incorrectly installed seal could permit water to enter the ecu causing a fault to develop. this will cause the vehicle's trailer abs warning lamp to illuminate immediately when the water contacts the board, deactivating all or part of the abs.
Consequence SummaryIf the warning lamp signal is ignored for a period of time, corrosion can develop eventually leaking to a complete loss of ecu function. the service brakes would continue to be fully functional.
Corrective SummaryRockwell is conducting the notification and remedy for this recall dealers will replace the ecu on these trailers.
NotesAlso contact the national highway traffic safety administration's auto safety hotline at 1-800-424-9393.